Filter
Top Products
Aug/07 MN2036400000
10
3. At the next screen select Mirrored then press Enter.
4. Select Manual configuration, then press Enter.
5. Select the Source drive, press Enter.
6. Select the Target drive, press Enter.
7. Enable Disk Copy, select Ye s , then press Enter.
Note: Enable Disk Copy – Copy current content of source driver to
mirror drive; Disable Disk Copy – RAID 1 set formed must be
repartitioned and reformatted to guarantee the consistency in their
contents.
8. Press Ctrl+E to exit the BIOS.
9. When asked Are you sure to exit(Y/N)?, press Y to exit and
reboot.
Note: If during boot the RAID BIOS reports an RAID1 set is in
Rebuild status, The rebuild will continue after boot sequence is
complete, disregard the message, continue booting, and let the Mirror
rebuild.