Polycom DOC2557A Server User Manual


 
Polycom RMX 1500 Hardware Guide
1-5
Site Requirements
This section describes the requirements your site must meet for safe
installation and operation of the system.
Safety Requirements
For your protection, please read these safety instructions completely
before operating the equipment.
Look carefully for potential hazards in your work area: moist floors,
ungrounded power cables, frayed power cords, missing safety
grounds and so forth.
Locate the main circuit breaker within the room.
Locate the emergency power OFF switch within the room.
Never assume that power is disconnected from a circuit.
Use only the power cord supplied with the system.
The power cord should only be connected to a power outlet that has a
protective ground contact.
Ensure that the power cord is easily accessible from the back of the
system at all times.
Place the equipment in a well-ventilated area where the vents are free
from obstruction.
Do not place heavy objects directly on top of the RMX 1500 unit.
Do not use liquids around your equipment.
Rack Mount Safety Precautions
The following precautions should be followed with regards to rack mount
safety:
Keep the area around the RMX 1500 clean and free of clutter.
Decide on a suitable location for the equipment rack that will hold the
RMX 1500 unit. It should be situated in a clean, dust-free area that is
well ventilated. Avoid areas where heat, electrical noise and
electromagnetic fields are generated. You will also need it placed
near a grounded power outlet.
Ensure that the leveling jacks on the bottom of the rack are fully
extended to the floor with the full weight of the rack resting on them.