Filter
Top Products
Part 4
is selected. Route the cable connection for the attachment kit to cable cover
area of Jiva series or TM4115 through the side of the cable cover. Break the
obstructing side wall of the cable cover in the cable entrance to the connector
area according to the needs.
Connection To PS/2 Keyboard
Refer to the pictures of bottom of KP100 with their partially enlarged
pictures to the right above. In the cavity found at rear side of KP100, there is a
PS/2 KB jack. Connect a standard PS/2 keyboard device to this jack and insert
the cable from the PS/2 keyboard device into the indentation for strain relief
and fixation when a PS/2 KB is required.
If a PS/2 keyboard is to be used in Jiva series with SD100 installed with
iButton receptor, please connect it to the female connector from SD100.
However, should there be any compatibility issue for this cascaded keyboard,
please try use another brand keyboard or a USB keyboard for application. If a
programmable keyboard is to be connected for programming, please
connect it between the host and the PS/2 KB interface of iButton reader in
SD100 / SD110 otherwise programming may fail.
B. FOR REAR TOP MOUNT KIT (PD302)
1. Separate the main unit of Jiva touch terminal from its stand assembly.
Consult a qualified electronic engineer to prepare power for the PD302 in
the service window on rear side of the main unit and then reassemble the
touch terminal.
2. Aim the bottom center cavity of PD302 series toward the
latch stub at rear of touch terminal main unit. Then aim
both metal and plastic hooks at rear of the PD302 series
toward the suitable ventilation openings on top rear of
the main unit. Please use a phillips head driver to fasten
the screws on the metal hook but not to overdo it so that
the metal hooks hold the ribs of the ventilation holes
from inside.
3. Plug the DB9 female connector to the COM port with power DC supply
Metal Hook
Plastic Hook
PS/2 KB Connector
KP100 Rear View
Indentation For Cable Holding
KP100 Inclined
Bottom View