Filter
Top Products
5 - 4
Switch Position 1 2 3 4 5 6 7 8
Serial interface w/
auto cutter
OFF OFF OFF OFF OFF OFF OFF OFF
Parallel interface w/
auto cutter
ON ON OFF OFF OFF OFF OFF OFF
C.
INTERNAL SWITCH
There is an extra internal 4 position DIP switch in PP-
7000II for more technical settings. To access these setup, please
first turn off the printer power and disconnect every cable from
the printer. Remove 4 screws from bottom of printer and remove
the plastic bottom cover with the power switch pressed. The 4
position DIP switch seats beside the 8 position DIP switch for
setup window with the switch position counting starts from the
nearest side to the 8 position DIP switch.
This 4 position DIP switch works as following:
Switch position Setting Effect
Ð
Function ON OFF
1
Factory internal setting Disable Default
2
Paper width 58 mm 80 mm
3
Line format 576 dots / line 512 dots / line
4
Reserved N. A. N. A.
The Switch position 1 default set to ON. The print speed is
fixed at 42.5 lines/sec.
Switch position 2 is usually set to OFF for use with 80 mm
paper width. When the printer is installed with the 58 mm paper
guide adaptor for use with the paper roll of 58 mm width, the
switch should be set to ON in PP-7000II & PP-7000IIUSB.
Switch position 3 is usually set to OFF for ESC/POS
command application that prints at 512 dots / line. Only technical
users shall set this switch to ON and make the printer work in the
576 dots / line format.