Filter
Top Products
Part 5
INSTALLATION GUIDES
CAUTION: Before any installation or cable connection to the set, please
always make certain that the system is turned off and the
external power source to the set is removed to prevent electric
hazard! Never touch any metal pin in the connectors or
circuits to avoid high voltage hazard or electrostatic discharge
damage unless the operator is well grounded. Failure to do the
above will void the product warranty!
OPENING CABLE COVER
Please follow steps A to G sequentially with reference to pictures
below to remove the cable cover.
DISCONNECTING CABLES
After removal of the cable cover, the connector area will be accessible
then. Please first note orientations of every existing cable connection and
then disconnect every cable properly before separation of main unit and the
adjustable stand assembly. Please note that the click lock spring has to be
pressed down prior to pulling out the connector such as the LAN port or the
CR port. Please also note that the fixing screws have to be loosened free prior
to disconnection such as the COM ports or the LPT port. Please always hold
the connector head itself instead of pulling on the cable wire when
disconnecting any connector. Failure to do this could damage the cable and
jack that is considered as an artificial destruction. Damages due to incorrect
Step A: Push lock/release lever back
Step B: Turn panel to most horizontal position
Step C: Insert the tip of a latchkey into one latch hole
Step D: Turn this key
counterclockwise to
the end
Step E: Do the same on the opposite side
Step F: Take the latchkey out of the hole
Step G: Pull at the removal hollow toward the user