Filter
Top Products
RUPS series software (or other power management software) and an interface
kits can be used with this UPS. Use only kits supplied or approved by the
manufacturer. If used, connect the interface cable to the 9 pin computer interface
port on the back panel of the UPS.
Note: Computer interface connection is optional. The UPS works properly
without a computer interface connection.
Caution: Use only factory supplied or authorized UPS monitoring cable !
4.3 Connect external battery pack (optional)
Before connecting, make sure the external battery pack and the connector cable
are compatible with this UPS.
Note: External battery connection is not necessary. The UPS works properly
without a external battery pack connection.
Caution: Use only factory supplied or external battery connection cable !
4.4 Connect the telephone/modem lines
Connect a single line telephone or a modem line into the telephone/modem surge
protection sockets on the back of the UPS. The RJ-45/RJ-11 modular sockets
accept standard single line telephone connections. This connection will require
another length of telephone cable (supplied).
Note: This connection is optional. It is not necessary to use this UPS.
Caution: The telephone line current limiting feature could be rendered
inoperable if improperly installed. Make sure that the telephone line from the
wall is plugged into the connector marked “IN”, and the device to be
protected (telephone, modem, etc.) is plugged into the connector marked
“OUT”.
Caution: This surge protection device is for indoor use only and never install
telephone wiring during a lightning storm.
4.5 Connect to Utility
Connect the AC input power connector to utility power to power up the UPS.
4.6 Charge the battery
The UPS charges its battery whenever it is connected to utility power. For best
results, charge the battery for 4 hours in the initial use.
4.7 Connect the loads
Plug the loads into the output connectors on the rear of the UPS. To use the UPS
as a master on/off switch, make sure all of the loads are switched on.
Caution: Never connect a laser printer or plotter to the UPS with other