Filter
Top Products
battery !
3.13 SNMP INTERFACE PORT (optional)
Provide the SNMP adapters for 10-BaseT Ethernet and Token Ring connectors.
Through RS232 communication port, the SNMP adapter make your UPS
becomes "SNMP manageable", provide a real time UPS and power status
information for the network manager.
Note: It's not necessary to use this function.
Caution: Use only factory supplied or authorized SNMP monitoring cable !
3.14 OUTPUT POWER RECEPTACLES
3.15 AC INPUT POWER RECEPTACLE
3.16 INPUT CIRCUIT BREAKER
It trips when the connected loads exceed the protected receptacle's capacity,
The center plungers of the circuit breakers extend when tripped.
3.17 SITE WIRING FAULT INDICATORS (RED LED)
It comes on when the UPS is connected to an improperly wired AC power outlet.
Note: This device is available on 110 Vac model only.
3.18 COMPUTER INTERFACE
Provide both RS-232 and relay signal to support NOVELL, UNIX, DOS,
WINDOWS and other operating systems.
4. Installation
4.0 Inspection
Inspect the UPS upon receipt. The packaging is recyclable; save it for reuse or
dispose of it properly.
4.1 Placement
Install the UPS in a protected area with adequate air flow and free of excessive
dust. Do not operate the UPS where the temperature and humidity is outside the
specified limits.
4.2 Connect Computer Interface (optional)