Filter
Top Products
Installing the USB Module
6
X-Slot USB Module User’s Guide : 05146515 A Uncontrolled Copy
Installing the USB Module
To install the USB module, perform the following steps:
1. Remove the X-Slot cover (or existing X-Slot module) on the
UPS rear panel. Retain the screws (see Figure 1).
NOTE UPSs with a single X-Slot may have another X-Slot module already installed
(such as the Powerware 9125 UPS). If there is a communication cable attached to this
module, disconnect the cable and then remove the X-Slot module.
Figure 1. Removing the Single-Port Module
2. To prevent electrostatic discharge (ESD), place one hand on a
metal surface such as the UPS rear panel.
Align the USB module with the slot guides and slide the module
into the slot until it is firmly seated.
3. Secure the USB module with the screws removed in Step 1.
Figure 2. Installing the USB Module
4. Connect the USB module cable to the USB port on your
computer.
5. Continue to the following section, “Installing the Software.”