Filter
Top Products
4. Place the Roll Drag Arm under the Roll Bar. The Roll Drag Arm may be placed on either
side of the Roll Bar, but the rounded tip of the Roll Drag Arm should be located in the
center of the inside of the core. The arm is spring loaded so that there is downward
pressure on the inside of the roll. This helps prevent application alignment problems
near the end of a roll. (Figure 2-3.)
5. Place the removed Roll Guide back on the Roll Bar and slide it close to, but not touching the
label stock roll. (Figure 2-4.)
DX850 Label Dispenser 5
Tip! Roll Guide Uprights
must not pinch the label
stock roll. (The label
stock roll must have free-
play between guides.)
Figure 2-4.
Figure 2-3.