Filter
Top Products
Printer Configuration
ETX/ACK Handshaking
ETX/ACK
Off
Possible Values: Off*, On
This feature enables or disables the ETX/ACK character handshaking method used to control data flow from the
host system to the printer. When enabled, an ACK character will be sent by the printer after an ETX character
has been received and processed out of the input buffer. ETX characters used for handshaking cannot be part of
an escape sequence.
RTS/CTS Handshaking
RTS/CTS
On
Possible Values: Off, On*
This feature enables or disables the RTS/CTS hardware handshaking method used to control data flow from the
host system to the printer. When enabled, the printer will activate the RTS signal whenever the printer’s input
buffer becomes nearly empty or when the printer’s control panel Setup Menus are active. The RTS signal will
be deasserted whenever the printer’s input buffer becomes nearly empty or Setup Mode has been exited.
Likewise, the printer will not send data to the host system if the host has asserted the CTS signal.
IrDA Interface
INTERFACE MENU
IrDA
Note that “IrDA” must be displayed on the bottom line of the display in order to access the following features
and for this interface to be active when Setup is exited.
Emulation
Emulation
Printek
Possible Values: Printek*, O’Neil, ZPL-II, Mt3, CPCL, Hex Dump
This feature sets the family of printer commands that may be used by a host application program to control the
various capabilities of the printer. The printer will only respond to commands valid for the currently selected
emulation. For more information, please refer to the MtP Series & FieldPro Programmer’s Manual.
24