Filter
Top Products
IBM Proprinter Emulation
Page 4-8
Character Sets
Select Character Set 1 ESC 7
Selects character set 1. Disables printing of character values 0 through 31 decimal,
and 128 through 159 decimal, so these characters will be treated as control codes.
Overrides the "Chars:" value in the "Setup: INTERFACE" menu.
Escape Sequence: ESC 7
Hexadecimal: 1B 37
Select Character Set 2 ESC 6
Selects character set 2. Enables printing of character values 0 through 31 decimal if
they are not used as control codes. Enables printing of character values 128 through
159 decimal, so these characters will not be treated as control codes. Overrides the
"Chars:" value in the "Setup: INTERFACE" menu.
Escape Sequence: ESC 6
Hexadecimal: 1B 36
Print Single Character ESC ^ n
Prints the character n from the all characters chart. This sequence may be used to
print a character that is normally treated as a control code.
Example: The following escape sequence will print a left arrow. This character is
normally not printable, since it is treated as the ESC control code.
Escape Sequence: ESC ^ ESC
Hexadecimal: 1B 5E 1B
Print Characters ESC \ n1 n2
Prints the next n1 + (n2 x 256) characters from the all characters chart. This sequence
may be used to print characters that are normally treated as a control codes.
Example: The following escape sequence will print an up arrow, a down arrow, a
right arrow, and a left arrow.
Escape Sequence: ESC \ 4 0 CAN EM SUB ESC
Hexadecimal: 1B 5C 04 00 18 19 1A 1B