Filter
Top Products
Tsunami QuickBridge II T1/E1 Quick Install Guide
Copyright © 2005 Proxim Corporation. All rights reserved. 4
STEP 3. PRE-ASSEMBLE HARDWARE
Proxim recommends that you pre-assemble the radio mounting hardware on the ground to familiarize yourself
with the equipment and check for any possible damaged or missing components before mounting the radios.
This includes attaching the mounting bracket and loosely attaching the washers, lock washers, and lock nuts to
the radios. Installers having prior installation experience may choose to skip this step and proceed with Step 3.
• For outdoor installation, the Tsunami QuickBridge II package includes a CAT 5e cable. This is a higher
grade than a standard cable.
• For indoor installation, use either a standard CAT 5e or a CAT 5 cable when connecting to the PC.
Pre-Assemble Mounting Hardware
Perform these steps on each radio to pre-assemble the mounting hardware on the radios:
1. Place mounting bracket onto mounting hole on rear of radio unit; insert mounting screw
2. Screw locking bolt onto mounting screw.
3. Raise mounting bracket to proper angle and tighten carriage bolt. Use a nut driver or socket wrench to
firmly tighten the carriage bolt.