Filter
Top Products
12
CONNECTING THE COMPUTER
CONNECTING THE PROJECTOR
––––––––
ADB
––––––––
––––––––
––––––––
––––––––
––––––––
––––––––
GND
––––––––
––––––––
––––––––
Serial Port
ADB Port
1
2
3
4
5
6
7
8
9
10
11
12
PS/2 Port
T x D
––––––––
––––––––
––––––––
––––––––
––––––––
READY
––––––––
GND
––––––––
––––––––
––––––––
––––––––
CLK
DATA
––––––––
––––––––
––––––––
––––––––
––––––––
GND
––––––––
––––––––
––––––––
Personal computers can be connected to the HDB15-pin (VGA) terminal on the projector.
● Connect the computer to these terminals using the VGA cable and VGA/MAC adapter (provided).
WARNING: For projectors, the VGA cable provided is designed to reduce RFI (Radio Frequency Interference) emissions.
For regulatory compliance reasons, this cable must be used and must not be replaced by any other cable.
Personal computers can be connected to the MDR20-pin terminal on the projector.
● Connect the computer to these terminals using the Digital Flat Panel cable (provided).
NOTE: Before using with digital connection, install (Plug in) Graphic Accelerator Board into PCI of the Computer and set up
the computer following instructions in the Graphic Accelerator Board package.
Personal computers can be connected to the computer input (Red, Green, Blue, Horiz. Sync. and Vert. Sync.) on the
projector.
● Connect the computer to these jacks using the BNC cables (not provided).
● Connect audio outputs from your computer to these jacks using the audio cable (not provided).
● If the audio input of the audio equipment is stereo, be sure to connect the right and left channels to the respective right
and left jacks.
● If the audio input of the audio equipment is monaural, connect it to the left jack.
● When the computer is operated by projector's remote control unit, connect three different type of cables (provided)
between projector control port and computer mouse port or serial port.
1
4
3
7
8
11
12
9
10
2
5
6
■ CONTROL PORT
AA
B
CONTROL PORT CABLE REMOVAL
HINT
Disconnect control port cable with
following steps.
1. Hold the portion (A)
of the connector
with one hand.
2. Pull the portion (B)
arrow direction and
remove connector.
CONNECTING TO THE COMPUTER INPUT 1 TERMINAL (HDB15) ANALOG
CONNECTING TO THE COMPUTER INPUT 1 TERMINAL (MDR20) DIGITAL
CONNECTING TO THE COMPUTER INPUT 2 JACKS (BNC x 5)
CONNECTING TO THE COMPUTER AUDIO INPUT JACKS (1 and 2)
CONNECTING TO THE MULTI-POLE 12-PIN (CONTROL PORT) CONNECTORS (1 and 2)
COMPUTER TYPE
IBM Compatible computer with PS/2 mouse port.
IBM Compatible computer with serial port.
Apple Machintosh computer with ADB mouse port.
CABLE
Mouse Cable for PS/2 port.
Mouse Cable for Serial port.
Mouse Cable for ADB port.