Filter
Top Products
SANbox 5000 Series Fibre Channel Switch Rack Mounting Guide
© 2008 QLogic Corporation. Specifications are subject to change without notice. All rights reserved worldwide. QLogic and the QLogic logo are registered trademarks of QLogic Corporation.
All other brand and product names are trademarks or registered trademarks of their respective owners. Information supplied by QLogic Corporation is believed to be accurate and reliable.
QLogic Corporation assumes no responsibility for any errors in this brochure. QLogic Corporation reserves the right, without notice, to make changes in product design or specifications.
D
D
Corporate Headquarters QLogic Corporation 26650 Aliso Viejo Parkway Aliso Viejo, CA 92656 949.389.6000 www.qlogic.com
Europe Headquarters QLogic (UK) LTD. Quatro House Lyon Way, Frimley Camberley Surrey, GU16 7ER UK +44 (0) 1276 804 670
Install Switch Rails
Install the switch rails on the switch using two
screws to secure each rail. The switch can be
mounted flush or with a 1.25 inch setback
depending on how you match the holes.
1. Switch rails, flush mount
2. Switch rails, with setback
3. Screws, 10-32 x 3/8
Install Rack Rails
Extend the rack rails to fit the inner dimensions of
the rack. The rail flanges on both ends fit inside
the rack. Be sure that the inner rail is toward the
front.
NOTE:
If the rack holes are square, use a centering
washer with each screw.
Fasten the rail flanges to the rack at both ends
with two screws using the upper and lower holes.
1. Screws
2. Inner rack rail
3. Centering washer
Install the Switch
1. Slide the switch and rail assembly into the rack
rails.
2. Fasten the switch to the rack with two screws:
one through each switch rail flange.
1. Screws
2
1
1
2
3
1
3
2
1
1