Filter
Top Products
4 Address Map and Special Registers
This chapter explains how the two UARTs and special registers are addressed,
as well as the layout of those registers. This material will be of interest to programmers
writing driver software for the DSCLP-100.
4.1 Base Address and Interrupt Level (IRQ)
The base address and IRQ used by the DSCLP-100 are determined by the
BIOS or operating system. Each serial port uses 8 consecutive I/O locations. The two
ports reside in a single block of I/O space in eight byte increments, for a total of 16
contiguous bytes, as shown in Figure 5.
Base Address + 8 to Base Address + 15Serial 2
Base Address + 0 to Base Address + 7Serial 1
I/O Address RangePort
Figure 6 --- Port Address Map
All two serial ports share the same IRQ. The DSCLP-100 signals a hardware
interrupt when any port requires service. The interrupt signal is maintained until no port
requires service. Interrupts are level-sensitive on the PCI bus.
The base address and IRQ are automatically detected by the device drivers
Quatech supplies for various operating systems. For cases where no device driver is
available, such as for operation under DOS, Quatech supplies the "QTPCI" DOS
software utility for manually determining the resources used. See page 0 for details.
6 DSCLP/SSCLP-100 User's Manual