Quick Eagle Networks 5844 Network Router User Manual


 
© 2007 Quick Eagle Networks. All rights reserved.
PDF07/07
The information presented herein may change without notice
and should be used for informational purposes only. 5840
Multiport Router, 5842 Multiport Router, 5844 Multiport Router,
and 4335 Access Router are trademarks of Quick Eagle
Networks.
5842/5844
T
2xT1 ANSI T1.403 ports, max. 4xT1
T1 (1.544 Mbps ± 50 bps)
100 ohm RJ-48C socket
B8ZS
ESF
0 db, -7.5 db, or -15 db LBO or DSX-1
DSX -1 to -26 db
T1 Network, internal, external T1 source
FCC Part 15, FCC Part 68, UL 1950
Third Edition, Industry Canada CS-03
VCCI Class 1 CAN/CSAC22.2 No. 950-95
T1 network, T1 payload, fractional T1 payload,
loop-up/loop-down commands
T1 set/reset codes, ESF FDL per
AT&T 54016 and ANSI T1.403 Annex B
1:1, 1:2, 1:4, 1:7, 3:24, QRW, all 0s,
all 1s, two user-programmable 24-bit
patterns bit error injection
Loss of signal, loss of frame, remote alarm
indication, alarm indication signal, CRC6, BPV,
OOF
Power/test, network line status, network
loopback, loopback acknowledge, IP address,
SW version level
Non-intrusive monitor send/receive selectable
per T1 line
0º - 50º C
-20º - 60º C
0 - 95% non-condensing
4.6 Km (15,000 ft)
Model
Network Interface
Ports
Line Rate
Connector Type
Line Code
Framing
Output Level
Input Level
System Timing
Regulatory
Diagnostics
Loopback Tests
Loopback Control
Test Patterns
Network Alarms
Front-panel Status VFD and tri-color LED
Bantom test jacks
Environmental
Operating Temperature
Storage Temperature
Relative Humidity
Maximum Altitude
Model Specific Features:
5842/5844 E
2xE1 G.703 ports, max. 4xE1
E1 (2.048 Mbps ± 50 bps)
120 ohm RJ-48C socket
HDB3
ITU-T G.704/CTR 12
ITU-T G.703/CTR 12
0 to 20 dB
E1 Network, internal, external E1 source
European harmonized standards 73/23 EEC,
91.31/EED, 89/336/EED, 93/68/EEC, and
91/263/EEC; UL 1950 3rd Ed.; CAN/CSA
C22.2 No. 950-95; Comision Federal de
Telecommunica-ciones; CISPR 22 Level B
(EN 55022)
E1 network, E1 payload, fractional E1
payload, loop-up/loop-down commands
E1 set/reset codes
1:1, 1:2, 1:4, 1:7, 3:24, QRW, all 0s, all 1s,
two user-programmable 24-bit patterns bit
error injection
Loss of signal, loss of frame, remote
alarm indication, alarm indication signal,
CRC4, CV, FE
Power/test, network line status,
network loopback, loopback acknow-
ledge, IP address, SW version level
Not applicable
0º - 50º C
-20º - 60º C
0 - 95% non-condensing
3.05 Km (10,000 ft)
WAN Protocols
Independent Frame Relay or PPP links
Multilink Frame Relay FRF.16.1
MLPPP (RFC1990)
MAC Learning Bridge (IEEE 802.1d) over
Frame Relay (RFC2427) or PPP
MPLS VLAN tag transparency and
bridging
VLAN 802.1q
Multiple multilink bundles and support of
MLPPP / MLFR bundle classes A,B & C
IP Based DiffServ QoS (Optional)
Standard-based DiffServ compliant
(RFCs: 2475, 2597, 2598)
Priority queues (WRR, CBQ),
Congestion control (WRED)
Six forwarding classes
(EF, AF1, AF2,AF3, AF4, BE)
Traffic metering
Multifield classifier (Src/Dest IP address,
protocols, and applications ports)
Frame Relay
UNI-U and UNI-N interfaces
1024 DLCIs
LMI: ANSI (Annex D), ITU (Annex A), and
FRF Rev 1.0
Routing Protocols
Static routing
RIP1, RIP2, OSPF, optional BGP-4 (I-BGP
and E-BGP)
IP Fast Forwarding
DHCP server, DHCP relay
IGMPv3, IGMP proxy, IGMP-PIM
VRRP, GRE
Security and Management
Classless IP addressing
NAT (1:1), NAPT(overloading, port
translation)
Stateful Packet Inspection designed for
ICSA compliance
Radius Authentication, Secure Shell (SSH)
Router Command Line Interface (CLI)
RFC-868 Time Sync and Local Time
Zone capability
Performance Monitoring
RMON-1: PPP and Frame Relay adapted
RMON-2: Protocol directory, network layer
host, protocol distribution, application layer
host, network layer matrix, application layer
matrix
Ethernet Interface
10/100 Base T
Connector: RJ-45 socket
Local Management
RS232C COMM Port (VT 100 emulation)
Connector: RJ-48C socket
Remote Management
Telnet (in-band and out-of-band via SLIP)
SNMPv3
Service Level Agreement Verification
Frame Relay SLA FRF.13 compliant:
Frame Delivery Ratio (FDR),
Data Delivery Ratio (DDR),
Frame Transfer Delay,
Service Availability
Physical
Dimensions: 1 RU, rack mountable
43.69 cm (17.2 in ) W, x 40.64 cm (16 in)
D, x 4.45 cm (1.75 in) H
Weight:5.45 kg (12 lbs.)
Power Requirements
Voltage: 100 VAC to 240 VAC, 50-60 Hz
or -40 VDC to -72 VDC (both on the same
platform)
Consumption: 30W maximum
Common Features:
Northern, Central & Eastern Europe
info_uk@quickeagle.com
Southern Europe, Middle East & Africa
info_france@quickeagle.com
Asia / Pacific Rim
info_apac@quickeagle.com
Latin, Central & South America
info_southamerica@quickeagle.com
Canada
info_ca@quickeagle.com
Headquarters
Quick Eagle Networks (USA)
830 Maude Avenue
Mountain View, CA94043
+1 650-962-8282 Phone
+1 650-962-7950 Fax
info@quickeagle.com
www.quickeagle.com