Filter
Top Products
2
5#('6;"24'%#76+105
Your surge protector connects your fax,
modem or other data line to a telephone line.
When using telephone lines, it is important
to follow these safety precautions.
R
• Never install telephone wiring during a
lightning storm.
• Never install a telephone jack in wet
locations unless the jack is specifically
designed for use in wet locations.
• Never touch uninsulated telephone
wires or terminals unless the telephone
line has been disconnected at the
network interface.
• Use caution when installing or
modifying telephone lines.
/1706+0)"6*'"
574)'"2416'%614
You can place the surge protector on a level
surface or mount it on a wall. Select a
location that is:
• near a grounded AC outlet
• near a telephone wall jack
• out of the way of normal activities
1. Use the supplied mounting template to
mark the holes on the selected location.
2. Drive in two wood screws (not supplied)
with heads that fit into the keyhole slots
on the bottom of the surge protector.
±
3. Align the surge protector’s keyhole slots
with the wood screws, then press the
surge protector down to secure it.
75+0)"6*'"%#$.'"
/
#0#)'/'06"4#%-
The five cable grooves on the top cable rack
and the four cable grooves on the bottom let
you place the related cable groups together
for easy identification. (See inset illustration
below.)
1. Slide the cable management rack all the
way out until it stops.
2. To snap cables into the grooves at the
top of the cable management rack,
connect the cables to the surge
protector then snap the cables into the
top grooves.
To snap cables into the grooves at the
bottom of the management rack, route
the cables below the rack’s frame and
connect the cables to the surge
protector, then snap the cables into the
bottom grooves.
%100'%6+105
%100'%6+0)"#"6'.'2*10'".+0'
1. Turn the surge protector off. Press
POWER
.
POWER
pops up, and the ON
indicator goes out.
2. Connect one end of a modular
telephone cord (not supplied) to the
surge protector's
FAX/MODEM/LAN IN
jack, and the other end to a telephone
wall jack.
±
3. Connect one end of an existing
telephone cord (not supplied) to the
surge protector's
FAX/MODEM OUT
jack
(RJ11), and the other end to your fax,
modem, or telephone.
R
"9#40+0)
ý
R
"
Do not use the surge protector with an
aquarium or near wet locations.
±
"016'"
±
"
• Use appropriate mounting anchors if you are
mounting the surge protector to drywall.
• The appropriate screw size is shown on the
mounting template.
Cable Management Rack
±
"016'"
±
"
FAX/MODEM IN and LAN IN share the same
RJ45 jack (FAX/MODEM/LAN IN). You cannot
connect both a Fax/Modem and LAN at the
same time.