Filter
Top Products
3
• To stop the countdown before the timer
reaches
0:00 00
, press
TIMER 1
or
TIMER 2
, then press
CLEAR
. The timer
resets to
0:00 00
.
When the timer reaches
0:00 00
, the alarm
sounds for 1 minute and
TIMES UP
flashes
above the active timer. Then, the timer counts
up in 1-second increments. Press any button
to silence the alarm.
When the alarm stops,
TIMES UP
continues
to flash and the timer continues to count up.
To stop the count, press the active timer’s but-
ton. The timer resets to
0:00 00
.
USING THE CLOCK AND
TIMERS
You can view the clock and use the timers at
the same time.
1. After you set the count up or countdown
timers, press
MODE
until
CLOCK
appears
in the upper left corner. The active
timer(s) flash.
2. Repeatedly press
MODE
to switch
between viewing the clock and the timers.
MOUNTING THE TIMER/
CLOCK
The magnet on the back of the timer/clock at-
taches to any metal surface, such as a refrig-
erator, oven or file cabinet.
You can also clip the timer/clock to a clipboard
or your clothing. Press down the upper end of
the clip, attach it to your clipboard or clothing,
and release the clip.
Using the Stand
1. Press down the
upper end of the
clip.
2. Use a pencil tip
to pull the small
stand out until it
fits onto the clip.
3. Set the timer on
a table or desk.
CARE
Keep the timer/clock dry; if it gets wet, wipe it
dry immediately. Use and store the timer/clock
only in normal temperature environments.
Handle the timer/clock carefully; do not drop
it. Keep the timer/clock away from dust and
dirt, and wipe it with a damp cloth occasionally
to keep it looking new.
Modifying or tampering with the timer/clock’s
internal components can cause a malfunction
and might invalidate its warranty. If your timer/
clock is not performing as it should, take it to
your local RadioShack store for assistance.
SPECIFICATIONS
Operating Voltage ............................ 1.25 to 1.65 V
Power Source .......... One LR44 button cell battery
Battery Life ......................................... About 1 year
Operating Temperature ............ 32–122 F (0–50 C)
Time Deviation ...................... 0.67 sec/day at 1.5V
Dimensions (HWD) .......... 1¼
×
2
5
/
8
×
3
3
/
8
Inches
(32
×
67
×
86 mm)
Weight ................................................ 2.5 oz (71 g)
Specifications are typical; individual units might
vary. Specifications are subject to change and im-
provement without notice.
Clip
Magnet
Stand