Filter
Top Products
Planning the installation
Where can the SeaTalk
2
Keyboard be mounted?
The Seatalk
2
keyboard can be flush or trunnion mounted either indoors or outdoors. It is
waterproof to CFR-46 standard.
Important:
The drain tube is not required if the keyboard is mounted indoors or in an area protected
from rain and/or sea spray. If mounting the keyboard outdoors or in an unprotected area
the drain tube will need to run to a suitable exit point below the level of the keyboard.
What configuration should I use?
How you connect the keyboard depends on the distances between your E-Series Display, the
keyboard and power source and whether or not you are connecting the keyboard to an
existing SeaTalk
2
system. Select the appropriate configuration from the following:
Configuration 1
Cable length between E-Series Display and keyboard less than 4.5m and
Not linking into an existing SeaTalk
2
system.
E-Series Display
SeaTalk
2
Keyboard
Junction box
Not supplied/accessory/
existing system
E Series display
TerminatorTerminator
SeaTalk
2
cable (1.5 m)
12v supply
Keyboard cable
(attached/3 m)
SeaTalk
2
Power/RF ground cable (1.5 m)
red
black grey
5A circuit breaker
Or:
Switch with 5A fuse
Supplied in the box
4
D7680-1
81253_1.book Page 4 Monday, May 9, 2005 9:36 AM