Filter
Top Products
32185/32186/32192/32195/32196 Group
Starter Kit User’s Manual M3A-2154G52B
REJ10B0223-0140/Rev.1.40 Jan. 2007 Page 5 of 79
3. Usage Precautions
3.1 Guaranteed Scope of the Starter Kit
The Starter Kit was developed for users to trial the 32185/32186/32192/32195/32196 Group
microcomputer specifications and development environment. Therefore, the results arising from the
use of the Starter Kit are not guaranteed.
When developing/debugging a system product using one of the M32R Family microcomputers,
please be sure to use official development tools separately available as you debug.
The Starter Kit should be run on the designated type of host machine (IBM PC/AT compatibles).
This designated type of host machine, however, is just an anticipated operating environment for the
Starter Kit and does not mean that the Starter Kit operates properly on all relevant types of
machines in all relevant environments (e.g., device drivers and peripheral units).
3.2 Regarding About System Power-on Sequence when Connected to the Emulator
- When turning on power, turn on M32100T-EZ-E first and then the M3A-2154 Evaluation
Board.
- When turning off power, turn off the M3A-2154 Evaluation Board first and then M32100T-EZ-E
When turning on power again after turning off power, wait for 10 seconds.
- Power to M32100T-EZ-E can be fed from USB cable.
Note: Unless the Starter Kit is powered on this sequence, the kit may operate erratically or break down.
3.3 About M3T-CC32R
M3T-CC32R (M32R Family Cross Tool Kit) included with the Starter Kit is a trial version whose
useful period is limited.
This version becomes unusable four months after it is installed. Past this period, it cannot be used
even by reinstalling.
If you wish to continue using M3T-CC32R, please purchase a production version of M3T-CC32R
separately from distributors.