Renesas 32195 Computer Hardware User Manual


 
32185/32186/32192/32195/32196 Group
Starter Kit User’s Manual M3A-2154G52B
REJ10B0223-0140/Rev.1.40 Jan. 2007 Page 16 of 79
When you have finished the above initialization, click the “OK” button to start M3T-PD32RM.
If M3T-PD32RM communicates normally with the target system, it starts up and the
M3T-PD32RM window shown in Figure 6.4 appears. For details on how to use it, refer to the
PD32RM Help.
Figure 6.4 M3T-PD32RM Window at Normal Startup
6.1.3 Error Messages During M3T-PD32RM Startup
If M3T-PD32RM cannot communicate normally with the target system, it appears an error
message in a pop-up box.
Causes of Errors on the M3A-2154 Evaluation Board
If the error pop-up box shown in Figure 6.5 appears when starting M3T-PD32RM, check whether
power is supplied to the M3A-2154 Evaluation Board and whether it is firmly connected to
M32100T-EZ-E.
Figure 6.5 Error Message at Startup (Error on the M3A-2154 Evaluation Board Side)
If the error pop-up box is appeared when starting M3T-PD32RM, correct the cause of error and
then click the “OK” button in that pop-up box. This brings up the initialize window, allowing you
to retry the startup. In this case, you can retry only once.
ERROR11473: Target MCU is not under control.
Please reset target systems.