Renesas M16C/6N Network Card User Manual


 
M306NKT-EPB User’s Manual 2. Setup
REJ10J0519-0200 Rev.2.00 Oct. 16, 2006 Page 27 of 104
2.6.3 LED Display When the Emulator Starts Up Normally
Figure 2.4 shows upper panel LED lighting status when the emulator started up properly. Check it when starting up the
emulator system.
Figure 2.4 LED display when the power turned on PC7501
IMPORTANT
Note on Memory Expansion or Microprocessor Mode:
z To use memory expansion or microprocessor mode, be sure to set pins RDY#, HOLD# and NMI# so that they
are not held low at startup. Otherwise the emulator system will not start up correctly.
Note on the Target Status POWER LED:
z If your MCU has two or more Vcc terminals, the LED does not light unless power is supplied to all the
terminals.
Note on the Target Status CLOCK LED:
z If the LED is not turned on, check the following.
(1) After powering on the PC7501 (before starting up the emulator debugger):
Make sure that the oscillator circuit board is properly installed in the PC7501 and it is oscillating normally.
(2) After the emulator debugger is started up (after the Init dialog box settings are completed):
Make sure that the oscillator selected in the Init dialog box is oscillating normally.
: ON
: OFF
: Flashing
POWER
CLOCK
RESET
RUN
WARNING
POWER
SAFE
ERROR
SYSTEM
STATUS
TARGET
STATUS
LED display when the emulator starts up normally
- If this LED does not light, check the voltage of the user system.
- Check that the power is supplied to all the power terminals.
- When the user system is not connected, this LED does not light.