Filter
Top Products
( 11 / 38 )
IMPORTANT
Note on the Work Area:
• When using this product, set to "2C00h" as a start address of the work area at the time of starting
up the emulator debugger (set by "F/W and Work Area" tab*
1
of Init dialog). In this case, the
emulator system uses the area below as a work area.
02C00h - 02C0Fh: Work area
*1 Supported by M3T-PD30 Ver.4.00 or later
Note on Accessing SFR Area:
• Access the below four registers by byte. They cannot be correctly accessed by word.
003FCh: Pull-up control register 0 (PUR0)
003FDh: Up control register 1 (PUR1)
003FEh: Port P1 drive capacity control register (DDR)
003FFh: Up control register 2 (PUR2)
Note on Commands that Access the Single-step Interrupt Vector Area:
• Do not perform the below debugging operations with the single step interrupt vector area (addresses
FFFECh - FFFEFh).
(1) Step execution of commands that access the single step interrupt vector area
(2) Program execution using commands that access the single step interrupt vector area when a
software breakpoint is set in those commands
Note on MAP References and Settings:
•When starting up the M30200T-RPD-E, initial MAP settings are as follows. Use generally the
M30200T-RPD-E in this setting.
00000h to 003FFh: "EXT"
00400h to FFFFFh: "INT" (emulation memory available)