Filter
Top Products
26. Select the Debug build configuration in the left hand drop
down list on the toolbar.
27. Click on the “Build” icon to compile, assemble and link the project.
4. Programming and Debug
28. Ensure the “SessionR8C_E8a_SYSTEM” session in the
right hand drop down list on the toolbar is selected.
29. Click the <Connect> button on the debug toolbar.
30. The “Emulator mode” dialog will be
shown. Select the correct MCU group
and device type (e.g. R8C/23 Group and
R5F21237 for E8A_RSKR8C23).
Please note that the “Emulator mode”
dialog shown here will only appear
the FIRST time you connect to the
target within a project. On subsequent
connections the “Emulator setting”
dialog will appear, please choose the
same options to connect.
31. Select “Erase Flash and Connect”.
32. If the E8a is to provide power to the CPU
board, select “Power Target from
Emulator” and choose the “5.0V” option.
Otherwise connect a 5V centre positive
supply.
33. Click <Next>.
34. The “Firmware Location” dialog will be
shown. Click <Next>, then <Finish>.
35. Accept any dialog warning that an older version of E8a firmware is necessary to work with the application. Allow
download of firmware to complete, this may take several seconds.
The connection to the Renesas Starter Kit will be completed and will activate the debugger buttons on the
High-performance Embedded Workshop toolbar.