Roland FJ-50 Printer User Manual


 
41
3 Maintenance
3-5 How to Replace the Separating Knife
If the separating knife, replace it with the replacement blade included with the FJ-50/40.
Do not touch the tip of the
separating knife with your fingers.
Doing so may result in injury.
Make sure the power to the unit is
off before attempting to replace the
separating knife.
Doing so may result in injury.
Press the [POWER] key to switch off the power.
1
Turn off the main power switch.
2
The POWER LED goes out
Remove the separating knife.
(1) Loosen the screw until it slips out.
(2) Grasp the screw portion, and slowly pull it out in
the direction of the arrow.
* Do not pull back while doing this.
3
Replace with a new knife.
4
If the blade remains in the carriage, use commercially
available tweezers to remove it.
Install the separating knife.
(1) Grasp the screw portion and slowly insert it into
the groove.
* Take care to ensure that the knife does not slip
(2) Tighten the screw.
5
(2)
(1)
Positioning groove
The knife is secured in
place by the magnet.
(2)
(1)