Filter
Top Products
Press down gently
(700 – 1000 gram
force) level.
Excessive force
Base tilts and cannot hold the workpiece level.
Excessive force causes
the material to bend,
shift, etc.
Appropriate force
Base holds the workpiece level.
4
Leveling the material
Press the material down with the Leveler very GENTLY. Great force is NOT necessary.
*Only about 1 kg maximum force is necessary to press down the leveler. Excessive force will have
a negative influence on the workpiece and the quality of imprinting.
The Adhesive Sheet
The adhesive sheet collects dust easily. Should the adhesive power become decreased, wash it
gently (don’t use a sponge or scrubbing brush) and dry naturally. The sheet will hold the workpiece
strongly again. (See the User’s manual Part 4, Maintenance.)
Adjusting the base
Turn the knob slowly and gently. No excessive force is necessary.
Yes
No
Yes
No