Filter
Top Products
SPECIFICATIONS
Input Power: 12 VAC, 700 mA
Output Power: 12 VDC on the Ring terminal of each OUT jack.
Size: 3.125" x 3.125" x 1.25"
Weight: 1 lb (.45 Kg)
1
ROLLS CORPORATION
5968 S 350 West
MURRAY UT 84107
1
PS16.SCH A
22 MAY 2002
Document Number:
Date:
Rev:
Sheet of
PS16 PM POWER CENTER
Ba
IN 9-15 VAC/VDC
HIGH OUT
PM SERIES OUTS
LOW OUT
J1
PHONE 1/4
C7
1U
J2
PHONE 1/4
J3
PHONE 1/4
J4
PHONE 1/4
2
3
1
J10
JAPDC
D5
LDRR
R1
4.7K
D1
1N4001
D2
1N4001
D3
1N4001
D4
1N4001
C17
2200UF 16V
J2
PHONE 1/4
1 2
3
J11
XLR JACK M
T1
XFMR AUDIO
I
1
G
2
O
3
U1
7812
SCHEMATIC
INTRODUCTION
Thank you for your purchase of the PS16 Personal Monitor Power Center.
The PS16 supplies the DC power and distributes the Monitor signal to up
to ten of the PM50s, the PM50sOB, and the PM350 units. This dramati-
cally increases efficiency and eliminates the need for multiple wall-warts
and adapter cables.
The power AND monitor signal are carried from each PS16 output using
an ordinary 1/4" stereo cable to the Monitor input of the PM50s, sOB, and
350. Using stereo “Y” adapters, up to ten of the Personal Monitor Amplifi-
ers may be daisy-chained.
NOTE: Older PM50s and PM50sOB units may need
a slight modification in order to operate with the
PS16. Any PM50s or PM50sOB WITHOUT a
ground lift jumper and mono/stereo jumper will need
this modification. Call the factory at (801) 263-9053
for details.
FEATURES
- Supplies power for up to ten PM50s, PM50sOB, and PM350 units.
- Directly supplies a monitor signal to four of the above units, indirectly (by
using stereo “Y” adapters) will provide signal for up to ten units.
- Unbalanced 1/4" and TRANSFORMER-balanced XLR inputs.
DESCRIPTION
LINE INPUTS
UNBALANCED: 1/4' Tip-Sleeve jack. Connects to a mixer's unbalanced
Monitor or Auxiliary Send.
BALANCED: Transformer isolated
female XLR jack.Connects to a mixer's
balanced Monitor or Auxiliary Send.
12VAC: Connects to the included Rolls
PS12 power adapter.
OUT 1 - 4: 1/4" Tip-Ring-Sleeve jacks.
The Tip of the connector contains the
audio signal, the Ring has the 12 volts
DC required to operate the Personal
Monitor devices, and the Sleeve con-
nects to ground.
power
status
PS16
+
-
LINE INPUTS
unbal
balanced
PERSONAL MONITOR
POWER CENTER
OUT 1 OUT 2 OUT 3 OUT 4
WARNING:
THIS UNIT MAY BE DAMAGED IF THE LIGHT IS OFF
WHEN POWER IS APPLIED - IMMEDIATELY UNPLUG
ALL OUTPUTS. USE TIP-RING-SLEEVE PLUGS ONLY.
12VAC
www.rolls.com
CONNECTION / OPERATION
• Connect the Send of the mixer to the appropriate Input of the PS16
(balanced or unbalanced).
• Connect the PS12 adapter to the 12VAC input of the PS16. The Power/
Status LED should light. If not, immediately unplug the power as this
indicates a short from the Ring of an Output jack to ground.
• Connect the TIP-RING-SLEEVE STEREO cables from the PS16
Outputs to the PM series Monitor Inputs. Refer to the Personal Monitor
unit owners manual for proper operation of that unit.
FOR APPLICATION DIAGRAMS, VISIT OUR WEBSITE
AT WWW.ROLLS.COM.