Filter
Top Products
16 Port 10/100 Mbps Nway Switch RC412 User Manual
4
Networking
Connecting computers to Switch
1. Make sure all computers to be connected to the Switch have
installed properly a network interface card.
2. Connect computer to the Switch with a twisted-pair cable. The
cable should have RJ-45 plugs. Use Category 5 cable for all
connections. Please pay attention to the length of each cable
should be less than 100 meters.
3. Plug one end of the cable to the RJ-45 port of the computer’s NIC.
Plug the other end to any available port on the Switch.
Front Panel LED Indications
LED Status Description
Power
ON Power On
ON A valid connection
Act
Blink Receiving Packets