Filter
Top Products
54M Wireless AP Router RNX-G400 User Manual
2
Connecting the Broadband Router
Prior to connecting the hardware, make sure to power off your Ethernet device, Cable/ADSL modem and Broadband
Router. Then follow the steps below to connect the related devices.
z Connect your computer to the LAN port.
Attach one end of the Ethernet cable with RJ-45 connector to your hub, switch or a computer’s Ethernet port, and the
other end to one of the LAN ports of your Broadband Router.
z Connect then Cable/ADSL Modem to the WAN port.
Connect the Ethernet cable attaching to your Cable/ADSL modem to the WAN port of your Broadband Router.
z Connect the power adapter.
Connect the single DC output connector of the power adapter to the power jack on the side of the Broadband Router.
Then plug the Power Adapter into an AC outlet.
z Power on the following devices in this order:
Cable/ADSL modem, Router, and PCs
The figure below illustrates a connection example:
Figure 1-1
1 PC Setup
You can manage the Broadband Router through the Web browser-based configuration utility. To configure the device via
Web browser, at least one properly configured computer must be connected to the device via Ethernet. The Broadband
Router is configured with the default IP address of 192.168.1.1 and subnet mask of 255.255.255.0 and its DHCP server is
enabled by default. Before setting up the Router, make sure your PCs are configured to obtain an IP (or TCP/IP) address
automatically from the Router by the steps below.