Filter
Top Products
ENCLOSURE RX-35MV Series User Manual
2
Setup mode under Windows 98/SE
Driver should be setup when firstly using the product, then plug-play available.
The below is an example for setup procedure under Windows98/SE system:
1. Take out the USB Enclosure, then pull out the inner case and take the inner
cover away.
2. Set your Hard Drive into the case, connect the cables carefully (Note: do not
connect 40p signal cable and 4p power cable mistakenly, meanwhile set the
Hard Drive device as “Master/MA”) and fix the screws tightly.
3. Slide the inner case into the frame, fix the screws and connect the power
cable & USB cable. (Note: the USB cable’s square end for USB mobile rack
and the flat end for your operating system or USB port of USB HUB)
4. Start Windows98/SE system. (or open)
5. Turn on the power of USB Enclosure (5.25” &3.5” Enclosure).
6. Windows98/SE will automatically find USB device and go into “add new
hardware” then enter “next”.
7. Choose “search available driver ” ,enter “next”.
8. Insert the right driver floppy or CD, choose “appointed device”, type
“corresponding product code” , and enter “next”.
9. Computer will display:
“USB Mass Storage Device”(USB1.1 Enclosure) or “USB Storage Adapter
AT2 (TPP)” (USB2.0 Enclosure)
10. Enter “finish”, the system will finish the setup automatically. Right setup will
be as the illustration: the circle shows the new device, no yellow, red, or green
question mark or praise mark. After finishing setup, the USB device will be
displayed on “My Computer”
Setup mode under Windows ME/2000/XP/VISTA system
Under Windows ME/2000/XP, the system can find and setup “USB Mass Storage
Device” directly.
Setup mode under MAC OS system
If your system is Mac OS 9.0 or above, the system can find the driver directly. If
your system is 8.6, you have to download and setup “USB MASS SORAGE
SUPPORT1.3.5” from SOFTWARE SUPPORT website: http://www.apple.com.
Note