Filter
Top Products
RBE-2000
7
OPERATION
Set-up
1. Plug in the power cord and turn the machine on.
2. Make sure the machine is on a flat, study surface.
3. Check to make sure the paper waste tray is empty and correctly fitted.
4. Move the adjustable paper edge guide to the size of paper you wish to punch.
5. Set the size of the margin on the paper by pulling out the margin depth adjuster to 1/4”, 1/8” or 1/10”.
6. Use the hole punch selectors to determine the right amount of holes to be punched for your document. Letter sized ( 81/2” x 11”)
paper uses 19 holes. The hole punch selectors can be pulled out to prevent punching holes, or pushed in to punch holes.
7. Select the right-sized comb and covers for your documents. For the appropriate comb sizes, refer to the chart of the binding
machine.
NOTE: Test pieces of scrap paper to make sure everything is aligned properly before punching your finished document.
Punching and Binding
1. Slide the front and back covers into the paper entry lengthwise. Press the punching button or step on the foot pedal
to punch.
2. Punch the remaining sheets in small batches that do not overload the machine. This machine can punch 20 sheets of
20lb./80gsm paper at one time.
3. Place the binding comb in between the comb pins with the open side facing up. Slowly pull the binding handle forward
to have the comb pullers open up the combs wide enough to insert the punched sheets. This machine binds up to
300 sheets using a 1 ½ ” comb.
4. Insert the punched sheets onto the open binding comb. For the best results, insert the front cover face down first,
then insert the rest of the sheets and back cover.
5. When all of the sheets are loaded onto the comb, pull the handle back to its original position. Remove the bound
document by lifting it up.