Filter
Top Products
1413
RSC-1400L
4. Flip the image over the top roller and hold on to the
release liner (Figure 4).
5. Press the foot pedal once, and then let it go while
slowly pulling the release liner as the board enters
the main roller nip (Figure 5)
6. Press the foot pedal once again when the board has
completely exited from the rear of the unit. Trim the
board if necessary.
Figure 4
Figure 5
16. Press the Stop button when the leader board has completely exited from the rollers.
17. Use the Cross Cutter to cut the leader board from the web (see page 9).
18. Set the nip setting to the appropriate position for the Over-lamination / Decaling
application.
11.2. Mounting
1. Lay the decaled image face down on a flat surface.
Carefully peel back and put a crease along the
edge of the release liner ( Approximately 1 in or
25mm, Figure 1).
2. With the image facing up, align the image onto the
board. Press firmly from the center out (Figure 2).
3. Adjust the pressure lever to ensure the proper
opening (Figure 3).
Figure 1
Figure 2
Figure 3