Filter
Top Products
RSC Series
109
11. LOADING FILM
Royal Sovereign films are wound with the adhesive side facing the inside of the roll
(adhesive in).
Figure 1
Figure 2
Figure 3
Figure 5Figure 4
Loading films to the top and bottom film shafts:
(See page 5 for assistance with parts identification).
1. Remove the top and bottom film shafts from the
machine.
2. Load a roll of pressure sensitive film to the top film
shaft (Figure 1). Center the film and tighten the core
screws (Figure 2).
3. Load a roll of mounting film or roll of craft paper to the
bottom film shaft. Do not tighten the core screws at
this time.(Figures 3)
Note: Please see the direction of the film on the top
and bottom shafts.
4. Load the top and bottom film shafts onto the machine
(Figure 4 & 5).
1. Adjust the auto grip to fit to the film and tighten the
auto grip screw (Figure 1 & 2).
2. Remove the upper and lower film shafts from the
machine and load the films (Center the upper and
lower films on the shaft). Note the direction of the
adhesives on the lower and upper films
(Figure 3 & 4).
3. Load the upper and lower film shafts on the
machine (Figure 5 & 6).
Figure 1
Figure 2
Figure 3
Figure 4
Figure 6
Figure 5
11.1 Installation of the core plugs
11.2 Installation of the auto grip