Filter
Top Products
If it happens, the speed needs to be lowered by one speed level and started again
after
signal on the LCD window.
3. In case of wrinkling or rolling of film due to wrong position of document,
is needed to be keeping pushed in order that document could come out
to the front with buzzer sound.
4. When document is much smaller than film, you should place it in the middle of film
for preventing wrinkle
5. Use cooling fan when you laminate continuously without break and
document is too hot.
The above laminating speed numbers are at the condition on regular voltage with
almost no film tension. There might be the possibility for difference to the
above numbers due to the change of voltage or adjustment of tension.
2. COLD LAMINATING
1. Put cold roll film on upper bar.(Set the same as methord of HOT film for
protect paper of lower part)
2. Pull COLD film, and fix it so that backside protecting paper can be wound on
take-up mandrel clockwise. (Revolve core to make protectingpaper tight a little bit.)
3. Set pressure lever at the proper position following to your lamination condition.
600mm(2ft)
800mm(2.6ft)
9 2000mm(6.6ft)4000mm(13.1ft)
3600mm(11.8ft)8 1800mm(5.9ft)
2000mm(6.56ft)
2400mm(7.9ft)
2800mm(9.2ft)
3200mm(10.5ft)
1000mm(3.3ft)
1200mm(3.9ft)
1400mm(4.6ft)
1600mm(5.2ft)
5
6
7
SPEED
1
2
3
***Laminating Speed at each level〔mm(ft)/min〕***
4
RSR-685/1050
800mm(2.6ft)
1200mm(3.9ft)
1600mm(5.2ft)
RSH-1050/1650
400mm(1.3ft)
REV
- 21 -