Filter
Top Products
21
Adjusting Front and Rear Roller
when the machine is running, check that
the top and the bottom films are fed in
without any wrinkles.
19
with different thickness of substrates.
5.
Check above steps 2 through 4
with
3mil & 5mil films.
lines indicate that it has less pressure
at that point.
4
.Laminating Test
–
Laminate samples
stop the machine for 30 seconds to
create a heat line. Then check to see if
you have two even parallel lines from
one end to other. Note: A narrow parallel
Front roller should be 2~3 and back
rollers should be 5~7.
2.
Checking for over all tension
–
3.
Pressure mark checking (Heat Line)
–
4. Adjustments
C.W – Increase pressure.
C.C.W – Decrease pressure.
1.
Using Push-Pull Scale
, measure
5 spots as shown on Figure B &C:
Pressure
•
Use Screwdriver
to
adjust the roller pressure:
Figure B
Figure C
Figure A
C.W
C.C.W