Filter
Top Products
RSS, RSR, RSH Series
109
9. USING FOOT PEDAL AND REMOTE CONTROL
10. USING CROSS CUTTER
USING FOOT PEDAL
Place the foot pedal on the floor in front of the machine.
Once all correct settings are displayed, you may use the
foot pedal to operate the laminator for “Hands Free
Operation.” To activate the machine, press the foot
pedal once and then release. Repeat to stop the rollers.
The cross cutter is located on the rear exit table of the machine.
1. After lamination, move the cutter approximately to the
center of the completed application at the desired point
of detachment (Figure 1).
2. Grasp film with one hand, press the cutter
downward into the application and slide it first to one
end of the application, then to the other end to
complete the cut (Figure 2 & 3).
USING REMOTE CONTROL
Located on the left hand side of the rear of the laminator, to
use press:
1. RUN : To activate the rollers.
2. STOP : To stop the rollers from turning.
3. REV : To reverse the rollers. Press and hold the button
(useful for jams or mis-feeds of media).
12 3
Figure 1
11. USING SLITTER
Only the RSR & RSS series have slitters included
1. Adjust the left and/or right slitters by loosening the
slitter adjuster knob (located between the front and
rear rollers.) Figure 1
2. Activate the slitter by turning the slitter knob(located
on the left side of the machine) clockwise. Figure 2
3. Once you activate the slitter then you can begin
lamination. Figure 3
4. To deactivate the slitter turn the slitter knob
counterclockwise. Figure 4
NOTE:
When the slitter becomes dull break off the
blade. Loosen the screw to pull down a new blade.
Once the new blade is down tighten the screw.
Figure 5
Figure 2
Figure 3
CAUTION
When the slitters are not in use please keep the slitters positioned at the
far left and right side to avoid injury.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5