Filter
Top Products
USM-2825-RKS1-012907-01 VideoFlex 2825 Wireless Multimedia Router 57
Verifying Proper Provisioning
Figure 33—LEDs
12. Make sure you are using the power adapter supplied by Ruckus Wireless.
13. Make sure the Power LED is lit. If it is not lit, make sure that the power cord is properly connected to the 2111
Adapter, and that the power supply adapter is properly connected to a functioning power outlet. If the error
persists, you have a hardware problem and should contact technical support.
14. Make sure your Network LED is lit. Make sure that the Ethernet cable connections are secure at the Ruckus
2111 adapter and your computer. The Network LED on the Ruckus 2111 adapter indicates link when the
adapter is fully seated in the port.
15. Make sure the Wireless LED is either steady or flashing Green. If is not lit, the Wireless settings may be
incorrect between the 2111 adapter and your computer.
16. If you still cannot see the video, proceed to the next section, ”Verifying Proper Provisioning.”
Verifying Proper Provisioning
To verify proper operation of the 2111, you can log in to the web interface of the 2111 using the following
steps.
Manually Configuring an IP Address on Your Computer
1. For Windows 2000: Select Start->Settings->Network and choose Dialup Connections
2. For Windows XP: Select Start->Settings->Control Panel-> Network Connections
3. Double-click the icon for the Local Area Connection designated for your home network. This is not the same
icon as your home wireless network.
4. In the Local Area Connection Properties window, select Internet Protocol (TCP/IP) and click Properties.
5. Click Use the following IP address. Enter an IP address that is on the same subnet as the default IP address
shown on the bottom of the 2111
6. Press the Tab key and allow the Subnet mask address to auto-fill to 255.255.255.0.
Power
WAN Wireless
Signal Quality
Connectivity Device
Association
Dome