Filter
Top Products
Source Selection is done by highlighting the desired source with the up or down arrows and
pressing ENTER. Sources may also be selected by pressing the left or right arrows on the front panel
or remote, or by one of the direct access buttons on the remote (page 13). Picture adjustments such
as color, tint, brightness, etc, are unique per source. To select a high-resolution source (input to the
RGB/Component 15PIN input on the PFP Controller), select either RGB HD or Component HD as
appropriate. If you wish to use the DVI input on the Projector, select DVI. The Controller will switch
the Projector’s inputs accordingly.
Aspect R
atio selection is done by highlighting 'Aspect Ratio' on the main menu and pressing enter.
The Aspect Ratio menu will then appear; and either ANAMORPHIC, LETTERBOX, VIRTUALWIDE or
4:3 may be selected. Aspect ratios may also be selected by pressing either the up or down arrow but-
tons, or by one of the direct access buttons on the remote. (Note: There is no discrete access for
VirtualWide).
Installa
tion is used for adjustments usually made during the initial installation. This includes Lamp
Mode, Keystone and Picture Orientation. Lamp Mode allows you to select between ‘Normal’ (full light
output) and ‘Low’ (80% of full light output). Keystone allows the adjustment of trapezoidal distortion
caused by angling the Projector; picture for ceiling or floor, front or rear installations. IR Code Set
allows the Controller to be set to one of four different IR Code Sets. This is useful if one of the Code
Sets has commands that are conflicting with other equipment, or other manufacturer’s IR Codes are
conflicting with the Controller. Lamp Hours may be checked in the Installation Menu as well.
17