Filter
Top Products
15
Use the included 3/16" Hex-head tool to adjust the
Vertical lens shift to center image vertically on
screen. See the chart on page 12 for shift range
available with the installed lens and screen size.
Next use the same 3/16" Hex-head tool to adjust the
Horizontal lens shift to center image horizontally on
screen. See chart on page 12 for shift range avail-
able. The tool will automatically center on top of the
adjustment nut when inserted into the access hole.
Lens Adjustments (Zoom / Focus / Shift)
With IR Receiver revealed on the front of the projec-
tor, go to the zoom / focus page of the remote con-
trol and adjust from the screen location for proper
size and focus. Be sure to aim the remote toward the
projector for best range. 100' range for lens zoom
and focus. The zoom buttons will size the image.
Use the focus buttons at the screen location to
resolve the individual pixels.
Lens zoom and focus are motorized adjustments
that are adjustable from the remote control. This is to
allow the installer to adjust focus while at the screen
for accurate results. The remote control has over
100' of range to the projector for long throw dis-
tances. The IR Receiver for the lens motor assembly
is located on the projector behind the front RUNCO
logo cover. Rotate the logo cover 90 degrees as
shown above to reveal the 0.5" diameter IR Receiver
opening.
IR receiver for lens
zoom / focus motors