6
Typical Set-up
The diagram on the right shows a
typical set-up for a project record-
ing studio using the S phantom
to connect two condenser micro-
phones to a personal hard disk
recorder that does not provide
phantom power.
Note: You can use either the XLR
or 1/4-inch phone jack output for
Mic 1 as depicted in the illustra-
tion by the dotted line.
For additional functionality, the
S phantom can be used as a one-
to-two mic splitter using the MIc1
XLR and 1/4-inch Outputs.
Operating the S Phantom
Disconnecting the S phantom
Follow the steps below for disconnecting your system.
• Lower the level controls, to the off position, for the input channels that have the S phan-
tom connected.
• Lower your master volume level control.
• Now, power-down the S phantom supply by removing the AC adapter.