Filter
Top Products
and worms across networks.
You can think of a firewall as a sentinel which identifies incoming data from the Internet and other networks.
A
ccording to the firewall settings, incoming data to your computer is either permitted or rejected.
The Windows Firewall is, by default, installed and activated on your client. However, your administrator can
turn it off. You can choose and select a different firewall. Therefore, it is not required for you to use the
Windows Firewall. Estimate the functions of other firewalls and choose the best one to fit your
requirements. To install and run a different firewall, you must turn off the Windows Firewall.
You must be logged on as administrator to turn the Windows Firewall on or off. Follow these steps to turn
the Windows Firewall on or off.
1. Run the Windows Firewall.
2. Click on one of these options under the General tab.
{ On (recommended) : This is the recommended setting for normal use.
{ On with no exceptions : This settings blocks all unwanted access to your client, including all
requests to programs and services selected in the Exceptions tab. Use this setting when you
need to protect your client to the maximum extent.
{ Off (Not recommended) : Turning off the Windows Firewall may make your client and network
more vulnerable to viruses and intruders.
Confi
g
urin
g
Utilities
Local Drive
C Drive
The C drive is used for the system. If there is less than 3MB of free space available, the client OS
cannot operate. Therefore, always ensure that there is a sufficient amount of free space available.
EWF can help maintain available space by preventing the C drive being written to directly.
Saving Files
Your client uses a fixed size of flash memory. Therefore, it is better to save files to the server
rather than to your client.
Mapping a Network Drive
The administrator can map a folder to a network drive. To keep the mapping information after restarting
the client, take note of these directions carefully.
- Select the Reconnect at logon checkbox in the Map Network Drive dialog box.
- If the EWF or FBWF is enabled, the changes are saved on the disk.
Installing MUI (Multi-language User Interface)
The MUI Setup program helps you set up languages on the XPe client. In addition, you can delete an
original language pack to extend the available free disk space. If you want to change the default
language, standards or formats, use the Regional Options in the Control Panel.
To add a language to your XPe client, follow these steps:
- Log on as an administrator.
- If the EWF or FBWF is enabled, you must disable it before beginning the installation.
-Click Start and click Run . Type muisetup.exe in the Open box and click OK . A list of languages
that can be installed is displayed as shown below.
- Select the language you want to install and click Install from the File menu. The installation will
begin.