Filter
Top Products
9
FrançaisEspañolDeutschItaliano EnglishPortuguese
Automatic Save
Whenever you open the on-screen menu and allow an adjustment window to remain
on-screen for about three seconds without pressing another button, this FPD automatically
saves any adjustments you have made. These changes are saved into a user area in the FPD.
User areas are reserved according to the signal frequency from your computer. This FPD can
save adjustments for up to five user modes. It has ten factory preset or preload modes, one
for each signal frequency as listed in the “Preset timing modes” on page 20.
If you have made no adjustments, the on-screen menu disappears and the FPD does not save
anything.
Direct-Access Features
The features described on this page and the next page can be accessed quickly, at the touch
of one button.
Once you finish making adjustments to a feature, push the EXIT button to turn off the menu
or allow the OSM to time-out and disappear automatically.
Auto Adjustment
Follow these instructions to enable or disable the
automatic screen adjustments for your FPD.
1
With the menu off, push the EXIT button.
The automatic adjustment display will appear.
2
Follow the directions previously given on
page 6.
Caution :
For Auto Adjustment to function correctly,
the monitor must display a full screen, colored
image.
Brightness
Follow these instructions to adjust the brightness of
the FPD’s display.
1
With the menu off, push the “
–
”
()
or
“
+
”
()
button. The brightness display
will appear.
2
Push the “
+
”
()
button to increase the
brightness; push the “
Ð
”
()
button to
decrease the brightness.
A
uto
Adj
ustment
No
Ð
Yes
+
EXIT: Exit key
Brightness
44
EXIT: Exit key
Ð
+
Adjusting Your FPD
sa800e2.fm Page 9 Monday, May 29, 2000 2:09 PM