Filter
Top Products
- 9 -
USER'S MANUAL
When there is no connection at the VGA and Video
input, the On Screen Display will show this message.
1. Press the MENU button to see the main menu.
2. Press
/
and ENTER button to select the main
menu.
3. Press
/
and ENTER (or
) button to select the
sub menu.
4. Press
/
and ENTER (or
) button to select
setting. (Or press
/
button to select setting)
5. Press the MENU button to exit.
Mode : Dynamic, Standard, Movie
1. Press the MENU and
/
button to select the
Picture menu.
2. Press the ENTER or
button to select the Mode
menu.
3. Press the ENTER or
button.
4. Press the
/
and ENTER button to select the
mode you want. (Dynamic, Standard, Movie )
5. Press the MENU button to exit.
You can return to the factory defaults picture
settings by selecting the "Reset".
(Refer to "Reset" on page 11)
Custom : Contrast,Brightness,Sharpness,
Color,Tint
Tint feature is enabled while input signal is NTSC mode.
1. Press the MENU and
/
button to select the
Picture menu.
2. Press the ENTER or
button.
3. Press the
/
button to select the setting you want.
(Contrast,Brightness,Sharpness,Color,Tint)
Press the ENTER button.
OSD Menu Configurations
USER'S MANUAL
No Signal Display
OSD Menu Selection
NOTE1: Press the
button to return to the
previous screen.
Press the MENU button to exit .
NOTE2: The OSD display will be disapear after 2
minutes if there is no button input.
No Signal
<Video mode>
Picture Menu
Check signal cable.
<VGA mode>
Picture
Mode : Dynamic
Contrast 100
Brightness 45
Sharpness 50
Color 55
Tint G 50 R 50
Color Tone : Normal
Backlight : 10
More
Move Enter Return
Picture
Mode :
Contrast 100
Brightness 45
Sharpness 50
Color 55
Tint G 50 R 50
Color Tone : Normal
Backlight : 10
More
Move Enter Return
Move Enter Return
Mode : Dynamic
Contrast 100
Brightness 45
Sharpness 50
Color 55
Tint G 50 R 50
Color Tone : Normal
Backlight : 10
More
Picture
Dynamic
Standard
Movie
SMT-1722-1922-Eng.indd 1:9 2008-7-10 9:20:32