Filter
Top Products
Q: Picture image is unstable and vibrates.
Ghost images are shown in the picture.
A: Check if the resolution and frequency set for the computer video card falls in the range supported
by the monitor.If not, reset them referring to the current Information under the monitor menu
and Preset Timing Modes.
Q: The image is too light or too dark
A: Adjust the Brightness and Contrast.(Refer to the Brightness, Contrast)
Q: The Power Indicator blinks.
A: The monitor is currently saving the changes made in settings to the OSD memory.
Q: The screen is blank and the power indicator light blinks every 0.5 or 1 seconds.
A: The monitor is using its power management system.
A: press a key on the keyboard.
Q: The screen is blank and is blinking.
A: If you see the "TEST GOOD" message on the screen when you press the MENU button, check
the cable connection between the monitor and the computer to ensure that the connector is
properly connected.
3. Problems related to Audio
Note
Problems related to audio signals and their solutions are listed below.
Q: No sound
A: Ensure that the audio cable is firmly connected to both the audio-in port on your monitor and
the audio-out port on your sound card.(Refer to the Connecting the monitor)
A: Check the volume level.(Refer to the Volume)
Q: The sound level is too low.
A: Check the volume level.(Refer to the Volume)
A: If the volume is still too low after turning the control to its maximum, check the volume control
on the computer sound card or software program.
4. Problems related to Remote Control
Note
Problems related to the remote control and their solutions are listed.
Q: The remote control buttons do not respond.
A: Check the battery polarities (+/-).
A: Check if the batteries have been exhausted.
A: Check if the power is on.
Troubleshooting