Filter
Top Products
5
■ Connect the display unit to VGA, BNC and Scart connector as
required.
1. Connect the in-line power connector to the connector attached to
the LCD monitor as shown above.
2. Connect the power cord of the LCD monitor to a wall outlet.
✐ As this product does not have a mains On/Off switch, please
ensure your mains plug is easily accessible.
✐ The LCD monitor is prepared for a mains voltage AC120V, 50Hz/
60Hz. To completely switch off the mains, or when the display
unit is not to be used for an extended period of time, it is advis-
able to disconnect the power cord from the power outlet.
✐ Please use the correct mains lead supplied with the set for your
area.
3. Warning: To prevent injury, the unit must be securely attached to
the wall in accordance with the installation instructions.
■ INPUT selection
To switch between AV1, AV2, AV3, PC or DVI press the INPUT button
on your remote control repeatedly
.
1. AV1
SCAR
T
connection
2. RGB
TTL
input (5V RGB signals) into SCART terminal
3. Y,Pb,Pr/ RGBHV connection (AV2)
This LCD monitor has a choice of Y, Pb, Pr or RGB H/V connections.
You can connect your DVD player to the Y, Pb, Pr terminals instead
of using a scart lead. This can support high definition in analogue
component form. RGB H/V can be used as a PC input via the BNC
terminals.Both options support a large range of resolutions (page 14).
4. A
V3
Composite (CVBS) signal input
A
V3 OUT is to output the composite video signal from the VIDEO IN
so that you can connect monitors with the use of a loop through
function.
5. DVI-D (Digital Video Interface)
This monitor has a DVI connector. This is located at the back of the
monitor next to the phono sockets. This input will support a large
range of resolutions as shown on page 14. See page 7 for details of
menu operation.
6. PC connection
This LCD monitor has a PC connector (PC-IN D-SUB). You can
connect a PC to the LCD monitor and use it as a monitor display (see
page 9). This input will support a large range of resolutions (see page
14). Audio can be connected via the 3.5mm PC audio in socket.
7. PJ Net IN: Has the ability for PJ-NET to be connected to
control the monitor using a network.
INST
INST
ALLA
ALLA
TION
TION
Step : 1 Mains Connection
AC Mai
ns
Outl
e
t
WARNING! High voltages are used in the operation of
this set. Refer service to qualified service personnel.
N5VW
AV2-IN
L
R
L
R
N5VW
GB GB
Step : 2 Connections
N5VW
AV2-IN
L
R
L
R
N5VW
PJ-Net