Filter
Top Products
EN-28
1. Turn off the projector.
2. If the projector is installed in a ceiling mount,
remove it from the mount.
3. Unplug the power cord.
4. Loosen the screw in the side of the lamp
cover and slide forward and remove the
cover.
5. Remove the screws from the lamp module,
raise the handle, and lift out the module.
6. Insert the new lamp module into the projector
and tighten the screws.
7. Replace the lamp cover and tighten the
screw.
8. Turn on the projector. If the lamp does not
turn on after the warm-up period, try
reinstalling the lamp.
9. Reset the lamp hour. Refer to the “Setting
(Computer/Video)” menu.
Dispose of the used lamp according to local regulations.
Ensure that screws are tightened properly. Screws not tightened fully may result in
injury or accidents.
Since the lamp is made of glass, do not drop the unit and do not scratch the glass.
Do not reuse the old lamp. This could cause the lamp to explode.
Be sure to turn off the projector and unplug the AC power cord before replacing the
lamp.
Do not use the projector with the lamp cover removed.
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give
the following information to the dealer.
Q Model No. of your projector : PDG-DSU21N/ DSU21E/ DSU21B
Q Replacement Lamp Type No. : POA-LMP118
(Service Parts No. 610 337 1764)