Sanyo Multimedia Projector Projector User Manual


 
13
Part Names and Functions
1
2
3
To insure safe operation, please observe the following precautions:
Use two (2) AA or LR6 type alkaline batteries.
Always replace batteries in sets.
Do not use a new battery with a used battery.
Avoid contact with water or liquid.
Do not expose the remote control to moisture or heat.
Do not drop the remote control.
If the battery has leaked on the remote control, carefully wipe the case clean and install new
batteries.
Risk of explosion if a battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Open the battery
compartment lid.
Install new batteries into
the compartment.
Replace the
compartment lid.
Two AA size batteries
For correct polarity (+
and –), be sure battery
terminals are in contact
with pins in the
compartment.
Point the remote control toward the projector (Infrared
Remote Receiver) when pressing the buttons. Maximum
operating range for the remote control is about 16.4’ (5 m)
and 60 degrees in front of the projector.
16.4’
(5 m)
60°
Remote control
Remote Control Operating Range
Remote Control Battery Installation