Filter
Top Products
EN-4
Air Circulation
Openings in the cabinet are provided for
ventilation and to ensure reliable operation
of the product and to protect it from
overheating, and these openings must not
be blocked or covered.
CAUTION
Hot air is exhausted from the exhaust vent.
When using or installing the projector, the
following precautions should be taken.
- Do not put any flammable object or spray
can near the projector, hot air is
exhausted from the ventilation holes.
- Keep the exhaust vent at least 90 cm
away from any objects.
- Do not touch a peripheral part of the
exhaust vent, especially screws and
metallic part. This area will become hot
while the projector is being used.
- Do not put anything on the cabinet.
Objects put on the cabinet will not only
get damaged but also cause fire hazard
by heat.
Cooling fans are provided to cool down the
projector. The fans’ running speed is
changed according to the temperature
inside the projector.
Moving the Projector
When moving the projector, replace the lens
cap and retract the elevator feet to prevent
damage to the lens and cabinet. When the
projector is not in use for an extended period,
put it into a suitable case with the lens side
up to protect the projector.
When handling the projector, do not drop,
bump, subject it to strong forces, or put other
things on the cabinet.
Installing the Projector
in Proper Position
Install the projector properly. Improper
Installation may reduce the lamp life and
cause a fire hazard.
Do not tilt the projector
sideways.
Do not point the projector
up to project an image.
Do not point the projector
down to project an image.
Do not put the projector
on either side to project
an image.
USE CAUTION IN CARRYING OR
TRANSPORTING THE PROJECTOR
- Do not drop or bump the projector, otherwise
damages or malfunctions may result.
- When carrying the projector, use a
suitable carrying case.
- Do not transport the projector by using a
courier or transport service in an unsuitable
transport case. This may cause damage to
the projector. To transport the projector
through a courier or transport service,
consult your dealer for their information.
- Do not put the projector in a case before
the projector is cooled enough.
Do not pitch the projector
more than 10 degrees
backward and forward.
10˚
10˚