Sanyo PDG-DSU20E Projector User Manual


 
EN-15
Replacing the Battery
For the first time use:
Remove the transparent insulation tape by pulling it before use.
For battery change:
1. Remove the battery holder.
2.
Remove the old Lithium coin cell and install new one (CR2025).
Ensure
that the side with the mark "+" is up.
3. Push the battery holder back into the remote control until you feel a
click.
Keep the battery out of the reach of children. There is a danger of death by accidentally
swallowing the battery.
Do not recharge the used battery or expose the battery to fire or water.
Do not dispose of the used battery along with household waste. Dispose of used
batteries according to local regulations.
Danger of explosion may happen if batteries are incorrectly replaced. Replace only with
the same type recommended by the manufacturer.