Filter
Top Products
29
BEFORE OPERATION
60°
R/C JACK
SERIAL PORT
OPEN OPEN
Connect a remote control cable to R/C jacks located on the wireless/wired
remote control unit and the side of the projector.
60°
The remote control unit can be used as wireless or wired remote control.
WIRED REMOTE
CABLE
1
Remove the battery
compartment lid. 2
Slide the batteries into the
compartment.
3
Replace the compartment lid.
Note : For correct polarity (+ and -
terminal), be sure the battery
terminals are in contact with the
pins in the compartment.
Point the remote control toward the projector
(Receiver window) whenever pressing the buttons.
Maximum operating range for the remote control is
about 16.4' (5m) and 60° front and rear of the
projector.
To insure safe operation, please observe the following precautions :
● Use (2) AA type alkaline batteries.
● Change two batteries at the same time.
● Do not use a new battery with a used battery.
● Avoid contact with water.
● Do not drop the remote control unit.
● If batteries have leaked on the remote control,
carefully wipe the case clean and load new batteries.
Remote Control Battery Installation
Using the Remote Control Unit (wireless)
Using the Remote Control Unit (wired)
16.4'
(5 m)
16.4'
(5 m)